opening the wright port?

[stracenzo]

Hi guys,
I'm new with this software and so far I like it a lot,but I have a little problem .
My UpNP router is detected but the forward pnp and the default are not. For this reason I'm not able to open a private text with anybody. I have also checked my firewall to make sure that all the related ports are open.
Any help is highly appreciaterd.
Regards Vincenzo

[L. D. James]

Hi guys,
I'm new with this software and so far I like it a lot,but I have a little problem .
My UpNP router is detected but the forward pnp and the default are not. For this reason I'm not able to open a private text with anybody. I have also checked my firewall to make sure that all the related ports are open.
Any help is highly appreciaterd.
Regards Vincenzo

What is the error you get when you try a private text to somebody?

Did you perform the chat fix provided in the troubleshooting section of the Installation steps from our front page ( FSInn Quick Install Steps – http://flightsim.apollo3.com )?

-- L. James

--
L. D. James
ljames@apollo3.com
www.apollo3.com/~ljames (http://www.apollo3.com/~ljames)

[stracenzo]

:confused:actually I dont get any error
let's say I type .msg<callsign> and then send ,but I'm not able to open a private conversation,however I'm able to chat to anybody if somebody calls me.
regards Vincenzo

[L. D. James]

:confused:actually I dont get any error
let's say I type .msg<callsign> and then send ,but I'm not able to open a private conversation,however I'm able to chat to anybody if somebody calls me.
regards Vincenzo

You have to type a message after the <callsign> to complete the command.

-- L. James

--
L. D. James
ljames@apollo3.com
www.apollo3.com/~ljames (http://www.apollo3.com/~ljames)

[stracenzo]

thanks man I'll try tonight

[stracenzo]

Thanks L. James,that has worked.
I wrongly taught that was like SB were first you have to establish a connection and then type the message.....regards Vincenzo